Product main product description:

Product model: STD-LD-180W-C-853

Rated power (W): 60W/100W/150W/180W/200W/210W

Input voltage: AC85-265V

Service life (H): 50000H

Luminous flux (LM): 5100-21000LM

Color temperature (K): 2700-6500K

Color rendering index (RA): >75

Life: 50000H

Illumination angle: 140°

Light source particle 1W, anti-lumen package

Protection level: IP65

Housing material: die-cast aluminum + tempered glass

Product weight: 12000G

Lamp size: 653*333*105mm

Packing quantity: 2PCS

Outer box size: 853*315*204mm




Scope of application:

Applicable to urban roads, residential areas, industrial areas, sidewalks, squares, parks, schools, villas, and other places.

 

Installation Notes:

According to the installation position of the luminaire, the lamp post is pre-buried. When installing, the street lamp is first fixed on the lamp post through the street lamp mounting bracket.

The lamp cable leads are connected as required (with connection marking). After checking, the power can be turned on and the street light can work.

 

Street lamp installation steps:

1. Put the lamp connector into the φ60 lamppost lamp arm, the depth of the nesting is about 200MM, and the safety screw and the safety hole on the lamp arm

The M8 screws must be tightened with a torque greater than 8.0 Nm.

2. Adjust the elevation angle of the lamp so that the light exit angle of the lamp reaches the specified requirements of the lamp, and then tighten the M20 screws on both sides of the lamp.

3. The power cord must be a 3-core cable with a protective grounding of at least 0.75MM2 certified by the National CCC. The phase line of the power cord should

Connected to the “L” of the luminaire, the neutral should be connected to the “ground” terminal of the luminaire, and the ground should be connected to the “ground” terminal of the luminaire.

4. Insert the connected tube cover into the lamp post fixing bracket so that the wires and terminals are enclosed in the cavity of the lamp arm to prevent water and ash.

The dust enters and reaches the dustproof and waterproof level specified by the lamp.

5, the installation is completed, the power can be used normally.

 

Troubleshooting and analysis:

First, the LED light is not bright

1. The power input terminal is not connected, please reconnect the input line to the input terminal;

2. The power supply is damaged. Please replace the power supply of the same level.

Second, the LED light source is not bright

1. The positive and negative poles of the light source are connected in reverse. Observe from the outside of the lens to confirm whether the red line is connected to the “+” pole, otherwise replace the positive and negative poles;

2, LED damage, use a reliable power test to determine if the light source is damaged.